Did you see the event at the same time in the Security log? ID Message. Event indicates that a packet IP layer is blocked. Event and Event are general Windows Firewall security audit, you should look into the event detail of the blocked connection attempt to decide whether that attempt should be allowed. If the connection attempt is malicious or not necessary in your environment, you can safely ignore it. Please try to check the detail to identify. Just for your information, if you want to disable the security audit from Windows Firewall, run the following command:.
For more information, please refer to the following link:. Best Regards,. Nina Liu. TechNet Subscriber Support in forum. If you have any feedback on our support, please contact tngfb microsoft. This is related to your firewall which block some traffic. Any update on this issue? If there is anything that I can do for you, please feel free to let me know. The reason this is happening to the original posting user is that the firewall was most likely disabled in the services control panel.
Turning off the auditing is not recommended as the problem would not have become apparent until a diagnostic investigation would have uncovered the issue. The replies in this thread were all intelligent and decent attempts to answer the original post but after going through many of these articles I found no such response to just check if the firewall was turned off, and turn it back on. Simple answer fixes the problem that seemingly took a lot of time for many users to resolve.
Success to all. Office Office Exchange Server. Not an IT pro? Windows Client. Privacy policy. This event generates when Windows Filtering Platform has blocked a network packet.
Note For recommendations, see Security Monitoring Recommendations for this event. If you convert the hexadecimal value to decimal, you can compare it to the values in Task Manager. You can get all local volume numbers by using diskpart utility. To find a specific Windows Filtering Platform filter by ID, run the following command: netsh wfp show filters. As a result of this command, the filters.
To find a specific Windows Filtering Platform layer ID, run the following command: netsh wfp show state. As a result of this command wfpstate. If you know that the computer should never contact or should never be contacted by certain network IP addresses, monitor for these addresses in Destination Address.
Skip to main content.
0コメント